Product Introduction:
The advantages of this technology are small floor area, low equipment height, light weight, convenient indoor layout, high dust removal efficiency, convenient bag replacement, easy bag replacement, and not limited by the height of indoor space. Modular box structure, easy to handle and install, reduce labor intensity. The flowered plate adopts punch forming technology, good flatness, high dimensional matching precision, to ensure the sealing of filter bag installation; High quality pulse valve fittings ensure service life. The special design and manufacturing technology of the bag cage not only guarantees the quality of the bag cage and the fixation of the bag assembly, but also increases the induced gas, improves the ash cleaning effect and reduces the design resistance compared with similar products. The upper intake structure is adopted to facilitate dust settling.
Technical performance
The technological process of side inserted flat bag pulse precipitator is shown in the figure below
Technical parameters of LYC type side inserted flat bag pulse dust collector
Dimensions Note:
1. The air volume is calculated with the filter wind speed of 1.5-2.0m/min. The actual wind speed should be selected according to different working conditions.
2. The air source required for ash cleaning is 400-600kPa, and the gas consumption per valve is about 0.05m per time. .
Shape dimensions of LYC type sideline insert flat bag pulse precipitator
Due to the modular shaped products of flat bag filter, there is no flexible and targeted special design according to the actual use of the process. The diameter and quantity of each bag and the selection of pulse valve are basically fixed when the flat bag filter is sprayed. Therefore, it is difficult to adjust the pressure of dust removal according to actual needs. The disadvantage is that when multiple flat bags are installed in the same room, most of the dust cakes after pulse jet cannot be directly shaken into the dust hopper at the bottom of the dust catcher, but are absorbed by the filter bag (tube) near the bottom of the box body. Therefore, the filter load near the bottom of the box will be higher than the filter load near the top of the box, the relative service life is shorter. Therefore, after a few months of using the filter, switch the upper and lower bags so that their resistance and service life are more uniform. In addition, this arrangement makes the resistance of the dust collector slightly higher than that of the same type of dust collector installed vertically with the bag.
简体中文
